VASAGLE Storage Bench With Cushion, Drawer, ULHS24WT

Precio relación producto buena. Parece resisitente. La entrega fue algo tortuosa por qué puse indicaciones para entregar en un horario y la empresa que realizó la entrega no las tomo en cuenta. Me estuvo presionando para que llegara a mi domicilio a las 17:00 h argumentando que ya habian concluido su ruta.

[UPDATE!!! = IT’S THE INSTRUCTION PAGE REFERRING TO MOUNTING THE RAIL TO THE DRAWER – All the pictures show the drawer face up til the last second, then they tell you to Mount the slide rails to the edge of the drawer – Mount them to the BOTTOM EDGE OF THE DRAWER – nOt the top edge like the picture has you to believe… If you look closely you’ll see the top face of the drawer has a half moon where you grab to open the drawer – Looking closely at the directions you’ll notice the drawer is flipped upside down in the last picture (as you do not see the half moon of the face when they’re showing the drawer rails being mounted)… If you Mount them to the bottom they’ll allow the drawer to sit flush to the top and close flush too – like it shows in the ad]

The drawer only opens halfway – sucks for a drawer that’s only 10 inches deep, giving you less than 5 inches. I ordered full extension soft close drawer slides to remedy this problem. More work, but the material is sturdy and these will hold up a long time, so I figured it would be worth it.

I’m leaving my original review with frustrations. Because dealing with the company was very difficult, even though many others have had the same issue and the company didn’t have a clue how to fix it, still gave a run around, and only helped me out after I submitted to return all three units.

[Original post below]
I bought 3 of these – 2 of them purchased a week apart from the first one – all have the exact same defect. The picture shows a drawer tucked perfectly into the top right corner, flush, with room for boots below.

The predrilled holes force you to place the drawer low with a 4″ gap over the top. No room for boots. Worse, the drawer rails come “factory bent” (they claim) and the company communication is [WAS] horrible. They repeat themselves over and over asking for more pictures saying they ‘can’t see any problems’ and “that’s the way it comes from the factory” and talked with me as if I didn’t know what I was doing. (I built cabinets and drawers from scratch for years – the drawer slides are junk [UPDATE!!! = IT’S THE INSTRUCTION PAGE REFERRING TO MOUNTING THE RAIL TO THE DRAWER – All the pictures show the drawer face up til the last second, then they tell you to Mount the slide rails to the edge of the drawer – Mount them to the BOTTOM EDGE OF THE DRAWER – nOt the top edge like the picture has you to believe… If you look closely you’ll see the top face of the drawer has a half moon where you grab to open the drawer – Looking closely at the directions you’ll notice the drawer is flipped upside down in the last picture (as you do not see the half moon of the face when they’re showing the drawer rails being mounted)… If you Mount them to the bottom they’ll allow the drawer to sit flush to the top and close flush too – like it shows in the ad]

[Continued update]
They refuse to send proper drawer slides that aren’t bent. The ones they send will force you to measure an entirely new spot on the already assembled shelving unit… Because you have to mount the side rail guides in before you build the unit and won’t see this until after fully assembled = the drawer will sit dropped back at a horrible angle, not flush. They are hoping you will not have the energy or desire to take apart the unit and send it back, as it takes hours to assemble.

Messaging with them is a waste of time. I truly believe they keep giving you the run around until your time to return has past. They’ve been absolutely zero help. I sent numerous photos and was requested to explain and send more, over and over, as they said they see no problem… I was even forced to draw on the pictures to clearly show the issues and yet they requested more pictures.

Others have posted pictures and complaints on this exact same problem. The customers also stated they didn’t have the energy to disassemble and were forced to go get their own drawer hardware too $$ out of pocket, take apart the entire shelving unit, measure for the drawer to sit at the correct height, drill and Mount the hardware, then reassemble the entire shelving unit all over, from the beginning.

Keep in mind, even if they send the correct drawer slides after dealing with this, I’ll have to take apart the entire unit and measure the correct height to mount the receiving rail guides on the shelving unit vertical walls. This due to the predrilled holes being far too low. [I’m doing this anyway now to install full extension drawer slides]

I’m done going in circles with them on messages. If they send straight drawer slides I’ll adjust the review accordingly.

When I bought this, my weight was roughly 288 lbs. I sat on this every morning and every afternoon to put my boots on for work, and still sit on it every morning and every afternoon for the same reason. It’s got plenty of space for you to work with, can hold a bunch of shoes and even has a little drawer that I use to store clean socks in. Assembly was super simple and everything went together correctly on the first try. Highly recommend if you’re like me and can’t stand having shoes strewn all over your house.

I bought these for my closet and lucky me, two fit perfectly along the wall of my closet. They were super easy to assemble and they literally look built in. Great find!

When buying furniture off amazon I’m usually worried about the quality of the materials, and whether or not the final assembly is structurally sound. To my surprise the materials and final assembly of the product has been one of the best I’ve personally purchased. VASAGLE will definitely be one of the furniture brands I’ll recommend, and purchase from in the future.

It was easy to put together. I only was frustrated with it when my husband tried to help. But got it together, made some sacrificial discussions when it came to what shoes could stay and what had to go. It was necessary. The size is decent not lucky like the one I had before it. The color and condition it arrived as was beautiful ❤️

1) This took a while to assemble – maybe 2 hours. Lots of screws
2) The dividers don’t attach to the rest of it – they just slide in on some metal pegs that kept popping out. I ended up using super glue to hold the pegs in place, but the dividers themselves can still be pulled out.